The Fix Is In

Walkover seat replacement is a complicated process, and the parts are heavy.  But I needed the exercise.

For the seat that we saw last time, which had been removed, the first step was to separate the back from the frame.  The back, like all of them in the main compartment, was professionally recovered many years ago, and they're all in excellent condition.  So I carried the seat out to the platform, removed the back, and carried the heavy cast-iron frame out of the car and to the ground.  Then I brought a replacement frame (originally from car 300) from storage to the 309, and put it more or less in place as seen here.  It's several inches into the aisle.  Then I managed to fit the back between the levers.  It's easier to insert and tighten the screws on the inside end of the back when there's more room between the seat and the wall.

Then the frame was moved into place, and carefully attached to the wall and the aisle bracket.

Finally, the arm rest was attached with a dozen screws, and the cushion put into place.  With some lubrication, it moves back and forth just the way it should.  Then I sat down to test it.  Whew!

And you know this has to be the same seat because the L7 hasn't moved.  I believe I have just three more to do in the 309, and several months to do it.

Meanwhile, back in Barn 4, the 306 team were hard at work.  Here Steve Keller and Fred are checking the electrical connections to the controller.

They also checked the alignment of the various parts of the pilot.  Here we see Gerry checking part of it; not shown are John and the others.

The Pennsy tool car looks great, at least the exterior does.

In the distance we see the 1268 and the 65.

Tim continued working on the 1268; these are seat cushions he assembled today.

He's usually moving too fast to be captured on camera.