Frank writes…
Sunday saw a successful “bench test” (in this case, pallet test) of the 18’s BB2 air compressor following some cleanup work.
A huge THANK YOU goes out to Joel and Richard, who put together our test setup (minus the air tanks - this test was done "unloaded") and got the pump all ready to test. Richard did quite a bit more polishing of the commutator, while yours truly did some additional clean-out beyond what had been done the previous week. Above is the initial test, using the welder; after this, we borrowed my father's "dropping-resistor stinger" to run the pump on maybe half or two-thirds voltage; and then finally came the full 600V test.If you look closely, you can see a bit of arcing under the brush, which is because the brushes still need to wear in a bit. But there was no "ring fire" or obvious sparking at all, just some small "snorts" at start-up, which evidently isn't uncommon. The next step is to install the pump on the car and run it "loaded" so that it has to actually build up air pressure.
We also took apart and cleaned out the car's air strainer, though unfortunately I neglected to get any photos of this. And I made a quick-and-dirty "EXPRESS" paper sign for one of the side sign boxes, taped it in place, and then tried the sign box circuit. Nothing. Hmm. Time for the famous Bill Wulfert Bulb Tester!
Here you go. It turns out that this circuit on the 18 uses 23W street railway bulbs, which we may not have any spares of, so that's not ideal. But all of them tested fine, and when I screwed them all back in, I tried the circuit on 600V again and voila!
One of the bulbs must have just been a little loose. Who knows.
With this, the car will look a bit more complete when it's running at night.
In other news from Barn 7, the concrete has been finished at the west end of the barn.
And we got a package that was brought back from the recent HRA convention in Pennsylvania! What could be in it? You'll just need to stay tuned to find out - don't touch that dial!
One of the bulbs must have just been a little loose. Who knows.
With this, the car will look a bit more complete when it's running at night.
In other news from Barn 7, the concrete has been finished at the west end of the barn.
And we got a package that was brought back from the recent HRA convention in Pennsylvania! What could be in it? You'll just need to stay tuned to find out - don't touch that dial!
Speaking of mysteries, we have another edition of What Is It? Get your answers in today if you can identify this item - the first person to answer correctly wins the undying admiration of Joel Ahrendt, and you can tell him we said so.







No comments:
Post a Comment